Notifications
Clear all

EZABL


thomw
Posts: 1
Registered
Topic starter
(@thomw)
New Member
Joined: 5 months ago

Is there a version of firmware for ender 3 pro that supports the EZABL unit?

Rgds Thom

Reply
3 Replies
Marlin Firmware Service
Posts: 199
(@marlin-firmware-service)
Estimable Member
Joined: 6 months ago

Sorry for the delay, I didn't get any notification about this post....

There isn't a pre-built nightly, however it's in experimental support via the Firmware Builder:

https://marlin.crc.id.au/builder/

Reply
2 Replies
sparklemotion
Registered
(@sparklemotion)
Joined: 5 months ago

Active Member
Posts: 8

@marlin-firmware-service I am trying out an EZABL. What exactly does the experimental support add to the firmware? Is it basically automating the instructions in this link? 

 

https://support.th3dstudio.com/hc/product-information/ezabl/ezabl-firmware-setup-for-vanilla-marlin/

Reply
Marlin Firmware Service
(@marlin-firmware-service)
Joined: 6 months ago

Estimable Member
Posts: 199

@sparklemotion Pretty much - but with a couple of changes to bring it inline with what I believe to be more standard options.

It's tagged as experimental as I don't have access to one of the probes to test with - and so far, have had no feedback from those who have tried it.

Reply
Scroll Up