Notifications
Clear all

Ender 3 V2 Firmware build


RLongino
Posts: 6
Registered
Topic starter
(@rlongino)
Nozzle
Joined: 2 months ago

I finally got the builder to compile firmware, but mesh bed leveling not showing up on display. The only thing I had in the build was, 235x235 bed, and mesh bed leveling.

Reply
4 Replies
Marlin Firmware Service
Posts: 163
(@marlin-firmware-service)
Stepper Motor
Joined: 3 months ago

Correct. The Marlin DWIN display does not currently support this.

Reply
2 Replies
AnthonyEnder
Registered
(@anthonyender)
Joined: 2 months ago

Heating Block
Posts: 16

@marlin-firmware-service I don't get this because the smith 3D firmware (using marlin) has both an auto and manual option on the stock LCD of the V2.

Reply
Marlin Firmware Service
(@marlin-firmware-service)
Joined: 3 months ago

Stepper Motor
Posts: 163

@anthonyender Smith 3D has created his own fork of Marlin and does not contribute his changes back to the Marlin project. It would be great if he did - as everyone would benefit, however that's his choice.

Reply
AnthonyEnder
Posts: 16
Registered
(@anthonyender)
Heating Block
Joined: 2 months ago

@marlin-firmware-service I don't get this because the smith 3D firmware (using marlin) has both an auto and manual option on the stock LCD of the V2.

Reply
Scroll Up