Forum

 

Notifications
Clear all

Ender 3 V2 custom firmware


ahusking
Posts: 1
Registered
Topic starter
(@ahusking)
New Member
Joined: 10 months ago

Hi everyone,

 

I created a custom firmware using the builder and the only setting I changed in the firmware was the bed size to be 230x230x250 and once I load the firmware and try to print, what ever I print just doesn't stick the first layer.

 

I've updated the start Gcode and resaved the file (also updating the size in Cura) but what I'm printing to test is less than 100x100.

 

I've reverted back to the stock firmware and everything is printing fine.

 

I'm also using OctoPrint from a RPI if that makes any difference

Reply