Forum

 

Notifications
Clear all

Ender 3 V2 + BLTOUCH - working until Marlin was installed to support Microswiss DD


mkillmer
Posts: 1
Registered
Topic starter
(@mkillmer)
New Member
Joined: 2 months ago

Hi - my Ender V2+BLtouch was working great on the creality firmware, then I installed the microswiss direct drive. I need to make a few changes to configuration.h, so I guess my only choice is to use marlin as the source for the creality version does not seem to be available (is that correct)?

Marin installs fine, and I added in the various defines as per videos, but now the Z axis only ever goes up. I've looked everywhere for a solution to this but haven't found anything that works.

any suggestion?

thanks,

Mark

 

Reply
1 Reply
kevin
Posts: 1045
Registered
(@kevin)
Noble Member
Joined: 7 months ago

Not sure if the motherboard deep file supports upgrading to the microswiss direct. 

Reply