Notifications
Clear all
Jan 06, 2021 8:33 am
Hello,
As the title says, I am running the Ender 3 V2, 4.2.7 board + BL Touch. I have been experiencing an issue where my z-offset cannot be adjusted during a print. I can change the value on the LCD screen, but the printer does not move in the z-direction. I have to cancel the print, adjust the z-offset in the menu settings, and restart the print. Has anybody seen this before? Do I have to change something? Can this be fixed in a later firmware release?
1 Reply
Jan 06, 2021 6:20 pm
There was a lot of conversation about this a number of months ago - and I thought it had been fixed.
See:
Can you advise what date firmware you're using? As this in theory should have been fixed a number of months ago.