Notifications
Clear all

Creality Ender-3 Max, SKR mini E3 V2.0 and BLTouch ..


jobert
Posts: 6
Registered
Topic starter
(@jobert)
Nozzle
Joined: 2 months ago

My Ender Max unfortunately came with a 4.2.2 mainboard, which I swapped for a BTT SKR Mini e3 V2.0.

Been trying, after a successful compile a week and a half ago, last night without success. ( exactly the same options with and without BLTouch) 

I cannot believe I’m the only one world wide to have a setup like this, and I need in order to install my BLTouch a firmware update. Looks like I’m stuck for infinity with a) printing 220x220x250, or b) without BLTouch.

 

suggestions, anyone? 

Reply
2 Replies
1 Reply
Marlin Firmware Service
(@marlin-firmware-service)
Joined: 4 months ago

Stepper Motor
Posts: 191

@jobert

If you can fire me the build ID, I can take a look.

Otherwise, if you use the normal Ender 3 version for the SKR Board, then manually change the bed size and Z Height in the builder, this should work.

Reply
jobert
Posts: 6
Registered
Topic starter
(@jobert)
Nozzle
Joined: 2 months ago

The builder was kinda of it’s wits, but yesterday I succeeded! Thank you for the quick response, you’re the best! 

kind regards,

 

jobert

Reply
Scroll Up