Forums Marlin Firmware Ser... Feature Requests Pause at height on ... Notifications Clear all Pause at height on ender v2 motherboard v4.2.2 Last Post RSS Posts: 4 Funfury Registered Topic starter Jan 06, 2021 1:14 pm (@funfury) Nozzle Joined: 2 months ago I d like for pause a t height work on this machine. Reply 5 Replies 3 Replies Funfury Registered (@funfury) Joined: 2 months ago Nozzle Posts: 4 Jan 06, 2021 1:21 pm Reply toFunfury Ender 3 v2 Reply Marlin Firmware Service Moderator (@marlin-firmware-service) Joined: 3 months ago Stepper Motor Posts: 164 Jan 06, 2021 6:10 pm Reply toFunfury @funfury It does work. You might have to mess around with M0 / M25 etc versions with your slicer to see which one works best. Reply Funfury Registered (@funfury) Joined: 2 months ago Nozzle Posts: 4 Jan 11, 2021 9:04 am Reply toMarlin Firmware Service @marlin-firmware-service i tried both and it didnt work,but when I tried “filament change “it did work . Is it because of M600? Reply Posts: 164 Marlin Firmware Service Moderator Jan 11, 2021 3:06 pm (@marlin-firmware-service) Stepper Motor Joined: 3 months ago Yeah - Filament Change uses M600 in most scenarios. Are you saying non of the pause methods worked on the Ender 3 V2? (I haven't tested this in a long while myself) Reply 1 Reply Funfury Registered (@funfury) Joined: 2 months ago Nozzle Posts: 4 Jan 29, 2021 12:52 am Reply toMarlin Firmware Service @marlin-firmware-service yes Reply