Forum

 

Notifications
Clear all

LCD firmware for Ender3 v2


WFR3DP
Posts: 3
Registered
Topic starter
(@wfr3dp)
New Member
Joined: 7 months ago

Hi!  Just signed up & downloaded Ender3-v4.2.2-Stock-20210214.bin f/w for my Ender3 V2 (v4.2.2 board, stock).  Wondering what LCD f/w I should use?  And install instructions?  Sorry this is such a noob question...

Cheers, /ghjk

Reply
Topic Tags
5 Replies
Marlin Firmware Service
Posts: 209
(@marlin-firmware-service)
Estimable Member
Joined: 10 months ago

Check the firmware you're using - the filename doesn't match the printer you mentioned.

Regarding the LCD, unless you purchased your Ender 3 V2 within the first few months of production, you don't need to update the LCD firmware.

Reply
4 Replies
WFR3DP
Registered
(@wfr3dp)
Joined: 7 months ago

New Member
Posts: 3

@marlin-firmware-service Thanks for your heads-up on the wrong file.  I should use Ender3-V2-Stock-20210221.bin instead (for v4.2.2 board)?

Regarding the LCD, unless you purchased your Ender 3 V2 within the first few months of production, you don't need to update the LCD firmware.

Don't know when the unit was mfg'd (delivered this Christmas by Santa!).  Is there a version number in the LCD code to guide us?

Reply
Marlin Firmware Service
(@marlin-firmware-service)
Joined: 10 months ago

Estimable Member
Posts: 209

@wfr3dp Yep - that's the correct filename.

There is no versioning on the LCD - however if things look blurry and not quite right after going to a non-Creality firmware, you can update. If the text and icons look clear, you're fine.

Reply
mateja176
Registered
(@mateja176)
Joined: 4 months ago

New Member
Posts: 1

@marlin-firmware-service Where can one download the LCD firmware?

Reply
Marlin Firmware Service
(@marlin-firmware-service)
Joined: 10 months ago

Estimable Member
Posts: 209

@mateja176 From the Ender 3 V2 FAQ:

https://marlin.crc.id.au/faq/

I can't link directly to it as the forum mangles the link...

Reply