Forum

 

Notifications
Clear all

Ender-3 Pro- 4.2.7-TMC2225 Marlin2.0.1-BLTouch-V1.1.2(without adapter board)


MichelBikkel
Posts: 1
Registered
Topic starter
(@michelbikkel)
New Member
Joined: 2 months ago

Hi, I installed the firmware on my Ender 3 Pro and set the Z-Offset right. So far so good.

Printing is doing wel, but! just before starting printing the printer checked only 1 position, just the middle of the print bed. Where can I set up the firmware to check atleast 9 points? 

Grtz Michel

Reply