Hi,
I recently upgraded my Ender 3 Pro successfully with the new board and BLTouch. Works great so far. The only problem left is with the Z-Offset calibration. I am familiar with the process (Autolevel, Move Z to desired position, Record the Value and use it as Z-Offset) but here is my problem: I don’t have issues to move the Z-Axis with the Move command to the desirable position where at the end I am using 0.025mm micro adjustments) BUT when I try to do the same to define the offset value found, I can only adjust in 0.01mm steps thus missing the optimal value.
Wondering whether anyone ran into same issue and have a fix for this
Kind regards
Peter
Update: Reading throughout the various sources, there seem to be an Z-Offset Wizard that can be enabled in the firmware that should does this. Any thoughts when this will be part of the Creality Firmware – last version seem to be from Aug 2020
@kevin – So how to get an updated version that allows me to better making adjustments to the bed level (Z-Probe offsett). I dare to compile it on my own as I am pretty satisfied with the crealitys firmware except this one thing
@gunhawk Sorry I do not know well about the coding. I prefer to higher my build plate by rotating the nuts under the hotbed.
hola gente
Recientemente actualice la ender 3 pro con la placa 4.2.7, pero no logro instalar el marlin para el bltouch , se queda vacía la barra de progreso.
si instalo el de la pantalla tactil que tengo se instala bien.
que puede estar pasando?
Saludos
