Notifications
Clear all

BTT SKR E3 Turbo on Ender 3 v2 w/ BL Touch


Redleg
Posts: 3
Registered
Topic starter
(@redleg)
Nozzle
Joined: 2 months ago

I have an Ender 3 V2 w/ a BL Touch but haven't been able to get firmware to compile correctly.

I've had to go back to my Creality 4.2.7 board for now because no one has any Firmware for the BTT SKR E3 Turbo on the Ender 3 v2.  I can find plenty for the Ender 3 / 3 Pro though.  The problem is the LCD on the v2.

Could you please add a version to the downloads section for the Ender 3 v2 w/ BLTouch (ABL Port)?

Reply
5 Replies
Marlin Firmware Service
Posts: 192
(@marlin-firmware-service)
Stepper Motor
Joined: 4 months ago
Reply
2 Replies
Redleg
Registered
(@redleg)
Joined: 2 months ago

Nozzle
Posts: 3

@marlin-firmware-service

 

Yes.  I need a version for the SKR E3 Turbo w/ BLTouch.

 

Reply
Marlin Firmware Service
(@marlin-firmware-service)
Joined: 4 months ago

Stepper Motor
Posts: 192

@redleg I don't believe the Ender 3 V2 screen is compatible with any of the SKR boards due to wiring differences.

Reply
Redleg
Posts: 3
Registered
Topic starter
(@redleg)
Nozzle
Joined: 2 months ago

I was told by BTT that it will work.

I just need a compiled version for the v2 display and a BLTouch.

Reply
1 Reply
Marlin Firmware Service
(@marlin-firmware-service)
Joined: 4 months ago

Stepper Motor
Posts: 192

@redleg From everything I understand, you've been told wrong.

The screen pinout is not compatible with the previous generation screen and doesn't work. A custom cable is required, but this hasn't been documented anywhere.

Reply
Scroll Up