Notifications
Clear all

BLTouch probing points grid off-center

Page 2 / 2

uki
Posts: 7
 uki
Registered
Topic starter
(@uki)
Nozzle
Joined: 2 months ago

Another thing quite annoying is "Hotend Idle Timeout" set to 5 min I believe. When I was messing around with bed leveling I noticed that when I send G29 command some time after hotend and bed preheat - the probing (~4,5 min) often is not finished when i got message "Hotend Idle Timeout" and bed and hotend heating is turned OFF (while bed is probing eg. 10/25). I can't change it by sending M85 S0 (disable idle timeout). Can it be changed to at least 15 min? It would be great!

Thanks!

Reply
Marlin Firmware Service
Posts: 157
(@marlin-firmware-service)
Stepper Motor
Joined: 3 months ago

The hotend does not need to be heated for a G29 to be performed - only the bed.

This timeout does not turn the bed heater off.

Reply
Page 2 / 2
Scroll Up