Notifications
Clear all

addition for ender 3 with SKR Mini e3 v2


tekman123
Posts: 2
Registered
Topic starter
(@tekman123)
New Member
Joined: 5 months ago

can you add an optional build for ender 3 with SKR Mini e3 v2 for bltouch and microswiss all metal hotend?

Reply
2 Replies
2 Replies
Marlin Firmware Service
(@marlin-firmware-service)
Joined: 6 months ago

Estimable Member
Posts: 199

@tekman123 I wasn't under the impression that anything needs to change for that?

I run a microswiss clone hotend with pretty much the same setup you describe and it works fine.

Reply
tekman123
Registered
(@tekman123)
Joined: 5 months ago

New Member
Posts: 2

@marlin-firmware-service ok. If there aren't really any changes then nevermind

Reply
Scroll Up