Notifications
Clear all

Add Support for M206 Command


EnderTiberius
Posts: 7
Registered
Topic starter
(@endertiberius)
Nozzle
Joined: 4 months ago

I have an Ender 3 V2 with an E3D Titan Aero installed. With the mount, it's offset some in X and quite a bit in Y. I tried to use the M206 command to set the home offsets, but the command was unknown. It also did not recognize M503 for viewing the current offsets. 

Obviously I could be mistaken, but I was under the impression that these were available in Marlin for a while now.

Reply
2 Replies
Marlin Firmware Service
Posts: 192
(@marlin-firmware-service)
Stepper Motor
Joined: 4 months ago
Reply
EnderTiberius
Posts: 7
Registered
Topic starter
(@endertiberius)
Nozzle
Joined: 4 months ago

I used the firmware builder on 12/15 to configure for

  • Ender 3 V2
  • 100 K Semitec 104 GT-2/104 NT-4R025H42G thermistor
  • Hotend Max 285
  • Firmware retract
  • S Curve Acceleration

All other settings were left on defaults.

Reply
Scroll Up