Forum

 

Notifications
Clear all

CR-30 PrintMill Bed adhesion! Horrible adhesion!


kevin
(@kevin)
Noble Member Registered
Joined: 7 months ago
Posts: 1045
Topic starter  

I have posted the following on Facebook. There are many kind people who give me ideas, but nothing of them solved my problem.

HELP!!! My print stuck on CR-30 too hard to take it off. The power of the stepper motor is not strong enough to strip the belt from the print. Heated the bed to 100℃, still did not help. Using a shovel seems to hurt the belt, so I have no idea what to do.

Anyone here could help me get out of this? Much appreciated!!!

 

The latest updates:

I broke the model, but the middle part was still stuck to the bed! Then using the rack to remove it bit by bit.

 


ReplyQuote