Forum

 

Notifications
Clear all

X and Y position wont move independently


Dalhartcustomz
(@dalhartcustomz)
New Member Registered
Joined: 7 months ago
Posts: 1
Topic starter  

My X and Y wont properly home. When I go to to move the X axis forword, it moves it on the Y axis also and vice versa. Both axis move at the same time when I go forword, backward, left, or right. Also when I go to level it, I click on the 1 - 5 and I get a BAD grinding because it doesn't know where it's at...


ReplyQuote
Harkon
(@harkon)
Trusted Member Registered
Joined: 1 year ago
Posts: 70
 

@dalhartcustomz likely you have the motors plugged into the incorrect sockets on the interface board


Mando liked
ReplyQuote
Mando
(@mando)
New Member Registered
Joined: 5 months ago
Posts: 1
 

@harkon Thanks! Had the same issue, print head only moved diagonally because the connecting cables for the two motors were accidentally swapped (E and Y motors, no 34 and 35 in manual).

This post was modified 5 months ago by Mando

ReplyQuote