TPU with the Ender 6
Hi guys! I have designed some tactile button caps that I would like to print with a flexible filament. Has anybody done this with the Ender 6 before? Any pointers before I wing it? 🤣
I made some gaskets and they turned out great. Print slow. I mean like 20mm/s slow. Increase feed rate to 110%. Be careful with retraction settings. To much retraction your hot end will clog.
I can't remember heat settings, but a bit of trial and error will get you there. As with most filaments, the first layer makes the print.
Did I mention you should print slow?