Forum

 

Notifications
Clear all

ENDER 6 controller board failure


esa
 esa
(@esa)
New Member Registered
Joined: 6 months ago
Posts: 3
Topic starter  

If controller board fuse is in place power supply is overloaded (=> output voltage 0VDC).

When controller board fuse is not in place printer start normally x,y,z servos are running etc.

Hot bed heater resistance is 2.2 ohm (262W) and nozzle heater resistance is 16.5 ohm (36W). Looks normal to me.

If heaters (bed and nozzle) cables are disconnect and fuse is connected printer stays dead.

 

So I think that controller board has a short circuit. 

Printer just went dead during power on.

Not bad for 3 weeks old printer.

Any ideas? 

 

 

This topic was modified 5 months ago by esa

ReplyQuote