I bought Ender 5 Pro last week, I was able to print couple of models successfully. Today the z axis stopped moving.
I thought the z stepper motor failed to work, but when i connected the x-axis cable it was working fine.
Also tried checking if the cable was faulty one, but it was working when i connected to other stepper motors.
Changed the firmware to 1.0.1 version, still not working. Please help.
@pavan501 You have tested z stepper and the cable is fine, so the rest is the mainboard. Please use the same method to test the Z pin socket on the mainboard.
@pavan501 Not sure if this is the same problem you have, but my Z-axis was not working correctly. The bed would go down, but it would not go up. I checked all the wires, connections, and switches and found nothing. Finally looked at the coupling for the Z-axis and found the lower screw on it was improperly installed and had been stripped out. I replaced it with a new larger screw and it's working ok.