Forum

 

Notifications
Clear all

Ender 5 Pro with Marlin 1.0.1


florin
(@florin)
New Member Registered
Joined: 8 months ago
Posts: 4
Topic starter  

Hi

I just got my Ender 5 Pro today and I see that I have the v1.0.1 firmware. I tried downloading "Ender-5-Pro-Marlin2.0.1-V1.0.1-Endstop" and putting it on an SD card. After power on and boot, it seems the printer tries to do an upgrade, but after it is finished, I see the same v1.0.1 in Information. And that is built in 25 April 2020.

I even opened the bottom case to make sure it has the 4.2.2 board and the board is there. 

I don't understand why it did not came with 2.0.1 on it.

Could someone please point me in the right direction?

Thank you


ReplyQuote
Eli liu
(@eli-liu)
Reputable Member Registered
Joined: 1 year ago
Posts: 462
 

ok, Marlin2.0.1 is the marlin version number, which is like a trunk and it normally will not display on the screen. V1.0.1 or whatever is the specific firmware version for your printer, like a branch, normally shows on the screen. 


ReplyQuote