Ender 5 Default values
Hi guys I am Toon/ from the Netherlands, bought ender 5 rev 184.108.40.206. 2 months ago
My 1st 3D printer. From start all prints went fine.
Suddenly printed filament became very thin and no adhesion to bed. I did the Feedrate test and only 40% (40cm) were used and not the 100cm.
E-steps value = 93.
I wanted to go back to the default settings because I think I changed one of the feed settings.
I downloaded the 220.127.116.11 (hex) firmware copied to formatted mem card. But After switching back on the printer nothing happend on the ender 5 screen. Just showing the present screens.
Please if you have some suggestions let me know.
Heb je hier wat aan.
Made by Scotland and the Netherlands 🙂