Hi guys I am Toon/ from the Netherlands, bought ender 5 rev 1.1.6.3. 2 months ago
My 1st 3D printer. From start all prints went fine.
Suddenly printed filament became very thin and no adhesion to bed. I did the Feedrate test and only 40% (40cm) were used and not the 100cm.
E-steps value = 93.
I wanted to go back to the default settings because I think I changed one of the feed settings.
I downloaded the 1.1.6.3 (hex) firmware copied to formatted mem card. But After switching back on the printer nothing happend on the ender 5 screen. Just showing the present screens.
Please if you have some suggestions let me know.
Thanks
Toon
Heb je hier wat aan.
https://duet3d.dozuki.com/Guide/Ender+3+Pro+and+Duet+Maestro+Guide+Part+4:+Calibration/40
Made by Scotland and the Netherlands 🙂