Forum

 

Notifications
Clear all

Ender 5, BLTOUCH glitches


ImprobableDuck
(@improbableduck)
New Member Registered
Joined: 7 months ago
Posts: 1
Topic starter  

Hello I was hopping to get some advice. I am new to the 3D printing scene and I am stumped. 

System:

Ender 5 board 1.1.4

BL Touch.

I have two main issues right now. When I do the auto bed level it seems to start just off a bit when it goes to the center then it runs the pattern when it goes to the left it goes to far and the bltouch won't touch the bed because it's right over about an inch.

Second issue is when adjusting the z access to lower the bed the lowest it goes is 300mm and that's only about half way down it won't go any further. 

I've tried twice installing the firmware for ender 5 bltouch on creality website and no difference.  Any ideas? 

Thanks so much. 


ReplyQuote