Forum


 

Notifications
Clear all

Clog half way through print

2 Posts
1 Users
0 Likes
428 Views
jaysmasher
(@jaysmasher)
New Member
Joined: 8 months ago
Posts: 2
Topic starter  

So I’ve been fighting this issue for a week.   My print will go great for the first about one inch and then my filament clogs.  I’m using Prusa PLA as I have a bunch of it.  I’ve tried raising the hotend temp, slowing down from the printing speed, and removing the retraction and I still get the same issue.  I’ve even tried different filaments but I still have the same problem.

I pull out the filament and see that it is about 2x as thick as it should be.  Thoughts on what I’m doing wrong? 


   
ReplyQuote
jaysmasher
(@jaysmasher)
New Member
Joined: 8 months ago
Posts: 2
Topic starter  

Here is a photo of me trying to print a Pikachu a few times


   
ReplyQuote