Forum

 

Notifications
Clear all

Video - 5 Plus Unable Bed Level


CLUBUGLY
(@clubugly)
New Member Registered
Joined: 10 months ago
Posts: 1
Topic starter  

can someone look at the video and tell me if I got a junk printer or is there something on my end. This is new setup as of 15 minutes ago. Thanks. Running latest firmware.


ReplyQuote
Topic Tags
kevin
(@kevin)
Noble Member Registered
Joined: 1 year ago
Posts: 1045
 

@clubugly Hello, the BL-touch probe did not pop out after his twice self-check.  So the bed will not stop as it did not know where it should stop.  I guess you can check the BL-touch probe. You can try to adjust the screw in the attached picture shows. The probe should be pop out when the bed is moving up.


ReplyQuote
JaykSKay
(@jaykskay)
New Member Registered
Joined: 3 months ago
Posts: 1
 

Did you get this resolved? I have a brand new 'out of the box' E5 Plus and have EXACTLY the same problem


ReplyQuote
Hogglett
(@hogglett)
New Member Registered
Joined: 3 months ago
Posts: 2
 

Just received my 5 plus  and got it assembled today .  This is my first printer and I’m having  some what the same issue as this…    

the bl touch probe never extends  but the bed never gets close to the bl touch   Like  not even as close as an inch .  Then it just flashes 


ReplyQuote