Notifications
Clear all

Trying to build source for Ender 5 plus


sk8ermeb
(@sk8ermeb)
New Member Registered
Joined: 6 months ago
Posts: 2
Topic starter  

Hello, I can't seem to find information on how to build the firmware for the ender 5 plus. 

I downloaded the source here:

I don't know if this is an arduino board, but I tried building in their ide  and received a build error "Pins for this chip not defined in Arduino.h"

I also tried following the instructions for marlin auto build here:

but the "auto build marlin" doesn't recognize it as a valid project folder. Additionally the creality folder in there only has one configuration and it is "CR-10"

Can anyone tell me how I am supposed to build this firmware? Thank you in advance. 


ReplyQuote
rc3105
(@rc3105)
Active Member Registered
Joined: 3 months ago
Posts: 6
 

That sounds like you don't have a target board selected. 

In the Arduino IDE go to the tools menu, then down to Board.  What do you have selected?

 


ReplyQuote