Notifications
Clear all
Topic starter
01/03/2021 7:51 pm
So, I am fairly new to 3D printing. I have had an Ender 3 V2 for about 2 months now, and I have had a ton of issues with it so far. Does anyone know how to fix the error message of "Home Z axis?" This message pops up every time I try to use the auto home function.
02/03/2021 4:16 am
Hi @spynate, do you use the original stock Firmware (1.0.2) with 4.2.2 board?
Check if the z-axis limit Microswitch is assembled properly ? Raise it 1..2mm in z direction maybe helps ?
good luck