Notifications
Clear all

Upgraded to direct drive and dual z axis, printer won’t boot now


SparkyBP
(@sparkybp)
New Member Registered
Joined: 2 months ago
Posts: 1
Topic starter  

I added the microswiss hot end and direct drive kit, then added my second x axis lead screw and motor. When I tried to boot the printer up it is stuck on the Creality screen. The fans turn on like it is trying to run but it won’t go to the menu screen. Any ideas? I am going to get a multimeter and check voltages here soon. 


ReplyQuote
Wurlitzerwilly
(@wurlitzerwilly)
Eminent Member Registered
Joined: 5 months ago
Posts: 42
 

What did you do exactly when you upgraded to direct drive?
Possible the stepper or connectors are faulty or have a short.
Did you upgrade any firmware?

 


ReplyQuote
Scroll Up