Forum

 

Notifications
Clear all

Print head diving into the print bed when trying to Auto home


Squeaky
(@squeaky)
New Member Registered
Joined: 4 months ago
Posts: 2
Topic starter  

Hi everyone. I recently purchased a refurbished v2. Initially everything went fine. I quickly became tired of leveling the bed and decided to switch to the yellow bed springs. I replaced the plastic extruder with the silver all metal extruder at the same time. After changing the parts I was able to home and tram the bed for printing, once. The print was bad so I stopped it. When I came back later on to try again, the print head just starts punching into the print bed while trying to home. I replaced to stop switch with a new one. Same thing is still going on. Maybe I need to open the panel concealing the board and check connections? 

 I've looked for answers all day and am coming up short. I don't want to send it back. Can anyone offer suggestions as to what I can do to fix the problem? 4.2.2 board with no bl touch. Thanks. 

 


ReplyQuote
Squeaky
(@squeaky)
New Member Registered
Joined: 4 months ago
Posts: 2
Topic starter  

I opened the bottom panel and checked the board. Everything is tight. I swapped the original springs back in. Still pushing down on the limit switch. 

 Could this be a square/level issue? Is it the board or the motor? 

 


ReplyQuote