Notifications
Clear all
Ender 3 V2
2
Posts
2
Users
0
Likes
1,507
Views
Topic starter
09/03/2021 7:16 am
I tried using “Pause at height” in cura to stop my print so could change filament to a different color. I sliced it and the print did stop at the height specified, but then immediately started again. This was done in Cura 4.8.
I’m told this is a firmware issue on the E3 V2. is this the case? is there a firmware fix in work for this? is there some other way to do this?
09/03/2021 8:10 am
@gcoates
There are new firmware versions from Jyers and ISTR this may have been one of the fixes: