Forum

 

Notifications
Clear all

How to print rubber stamps with ender v3.2


Mearchenmond
(@mearchenmond)
New Member Registered
Joined: 8 months ago
Posts: 1
Topic starter  

Hello,

I am currently trying to make rubber stamps and am using flex for it.

My current issue is, that the highest layer is not flat - so when stamping, the lines of the image are not smooth and very bulky.

I have also tried to activate ironing on the highest layer, - it became flat in the middle of the line, but the edges were much higher thus creating two lines instead of one smooth line...

Does anyone have any suggestions or did something similar?


ReplyQuote
Eli liu
(@eli-liu)
Reputable Member Registered
Joined: 1 year ago
Posts: 462
 

For some 3D printed parts, we have to post-process it, like deburring and filing. 

Have you tried putting the stamp side at the bottom and print it first, to leave a nice surface. no support needed(depends on the complexity of the design).


ReplyQuote