Notifications
Clear all

Extruder motor not start randomly after change to 415 steps for BMG.


jonatasfv
(@jonatasfv)
New Member Registered
Joined: 2 months ago
Posts: 3
Topic starter  

Hello,

 

after change steps to 415 for extruder (direct on LCD) and install BMG dual gear, randomly extruder motor not start only on a new print. After I restart Ender 3 v2, extruder work and print complete ok, without errors, but, after try to start a new print, extruder not work again and go to work if a try again and again or restart a printer.

My Ender have 2-3 months.

Any idea?

 

I`m use this firmware: https://marlin.crc.id.au/firmware/Ender%203%20V2%20-%20BLTouch/

 

 

This topic was modified 2 months ago by jonatasfv

ReplyQuote
Topic Tags
jonatasfv
(@jonatasfv)
New Member Registered
Joined: 2 months ago
Posts: 3
Topic starter  

any idea?


ReplyQuote
kevin
(@kevin)
Honorable Member Admin
Joined: 3 months ago
Posts: 668
 

@jonatasfv How about reflashing back to the Creality default firmware.


ReplyQuote
jonatasfv
(@jonatasfv)
New Member Registered
Joined: 2 months ago
Posts: 3
Topic starter  

@kevin I talked about the firmware just as extra information, I had been using it for a long time, without problems.


ReplyQuote
kevin
(@kevin)
Honorable Member Admin
Joined: 3 months ago
Posts: 668
 

@jonatasfv I do not like to flash the firmware if the printer is fine. 😯 


ReplyQuote
Scroll Up