Notifications
Clear all

ender 3 v2 idle after temperature reached


clownnut
(@clownnut)
Active Member Registered
Joined: 3 months ago
Posts: 5
Topic starter  

ok, i dont know how or what i need to do to change it.

the print run fine as long as i run at 200. if i run above that it will just idle after temperature is reached.
so i set the temp to 210, it will reach 213 and then fan ramp up and drop the temp down to 206 and then the fan ramp down, temp will reach 213 again, then repeat. 

as soon as i go into tune and change the temp to 200, the printer instantly start.

i wont have this problem if i set the temp in the slicer as 200.

 


ReplyQuote
yba2cuo3
(@yba2cuo3)
New Member Registered
Joined: 3 months ago
Posts: 1
 

You might try to tune your extruder PID.  I was having fluctuations of several degrees also & performing a PID tune fixed the issue.  See this video for guidance: 


ReplyQuote
clownnut
(@clownnut)
Active Member Registered
Joined: 3 months ago
Posts: 5
Topic starter  

@yba2cuo3
ok i will give that a try tomorrow and see if that solve the problem
thanks

 


ReplyQuote
clownnut
(@clownnut)
Active Member Registered
Joined: 3 months ago
Posts: 5
Topic starter  

@yba2cuo3
thanks, that seem to do the trick.


ReplyQuote