Forum

 

Notifications
Clear all

E Steps Extruder moving wrong way


GwnXander
(@gwnxander)
New Member Registered
Joined: 8 months ago
Posts: 3
Topic starter  

Hi,

I just upgraded the plastic extruder on my ender 3 v2.

But now the extruder motor is moving backwards so the filament is going out when i want it to go in.

How can i fix this?

 

I have a 4.2.7 motherboard.


ReplyQuote
kevin
(@kevin)
Noble Member Registered
Joined: 7 months ago
Posts: 1045
 

@gwnxander Weird!Did you install the opposite direction? or reversed wiring? Could you please check or share a picture of that. Thanks.


Matthew liked
ReplyQuote
freddo4
(@freddo4)
New Member Registered
Joined: 2 months ago
Posts: 2
 

I have the same problem. I upgraded the hot end on my Ender 3 v 2 (4.2.2 board) and now the filament feed stepper motor turns backwards.


ReplyQuote
freddo4
(@freddo4)
New Member Registered
Joined: 2 months ago
Posts: 2
 

Problem solved - I had the connector inserted upside down on the stepper motor.  Rookie mistake!


ReplyQuote
kevin
(@kevin)
Noble Member Registered
Joined: 7 months ago
Posts: 1045
 

@freddo4 LOL. People often do this wrong.


ReplyQuote