Clear all

Did i destroy my ender 3 v2 installing a BLTouch ?

New Member Registered
Joined: 8 months ago
Posts: 2
Topic starter  

Dear all, 

I get my brand new Ender 3 V2 two days ago and succeed in few prints. I tried to install an official BLtouch kit today. I followed the instructions. 

Unfortunately, when powering again my printer, the screen was black, and a strange noise came from the extruder (see video). I was unable to flash the firmware.

I am very anxious becaus unplugging the Bltouch from the motherBoard did not solve the problem (same symptoms). I check all the wires and connection and it seems OK.

Did i break my brand new printer ? ? 

Any Help would be highly appreciated !!!

Thanks a ton in advance, 

Hervé (France).

This topic was modified 8 months ago by Pr_Geek