Clear all

Change flowrate during print

New Member Registered
Joined: 8 months ago
Posts: 1
Topic starter  

Is there a way to change the flow rate during a print?

I can set flowrates in cura for different parts of the print but there are times i notice that the flow needs to be increased or decreased during a print and want to change it on the fly. Is that possible with the Ender 3v2?  

Not a lot of adjustments available in tuning during print. 

Thank you 

Active Member Registered
Joined: 9 months ago
Posts: 15

use M221 if attached to pc/octoprint. Otherwise you can adjust the % at the printer. That does a M220, which adjusts not only flowrate but also the feedrate