Ender 3 V2

calibrating e-steps

First post and replies  | Last post by Daveyman123, 2 hours ago

Scars after 2 inches

First post and replies  | Last post by leandro3dvieira, 7 hours ago

firmware for filament runout sensor w/v4.2.2 board

First post and replies  | Last post by Mac-7, 8 hours ago

PLA coming out from the sides of the nozzle

First post and replies  | Last post by kevin, 24 hours ago

Layer Shift, Ender 3 V2

First post and replies  | Last post by Demon85, 1 day ago

Ender 3 V2 Shutdown mid print

First post and replies  | Last post by tundrwd, 2 days ago

No Bed adhesion

First post and replies  | Last post by tundrwd, 2 days ago

Parts/components most likely to die, and timeframes for them?

First post and replies  | Last post by tundrwd, 2 days ago

vref after Dual Z upgrade?

First post and replies  | Last post by blocked, 4 days ago

Z axis homing issue

First post and replies  | Last post by tosio3D, 4 days ago

low voltage after hotend replacement - short?

First post and replies  | Last post by Eli liu, 5 days ago

print head gantry binding on left z-axis

First post and replies  | Last post by Wurlitzerwilly, 1 week ago

Extruder

First post and replies  | Last post by bcarty, 1 week ago

Layer shift on Y axis, worn out thread

First post and replies  | Last post by john2y92, 1 week ago

New to 3d printing disaster (kind of)

First post and replies  | Last post by Daveyman123, 1 week ago