Forum

 

Wired under-extruti...
 
Notifications
Clear all

Wired under-extrution in the middle of print


EdMorphy
(@edmorphy)
New Member Registered
Joined: 5 months ago
Posts: 2
Topic starter  

Hi,

I've recently bought an Ender 3 v2, everything was OK for a couple of prints but gradually my printer under-extrude filament, at first I was one or two layers but now every time I want to print, in the middle of print my heat break starts to clog and finally jams, at this point, I can not push filament even with my hand, and when I remove the nozzle I notice that filament is hard even though my temperature is high. I changed my hot end along with the thermistor. Also, I've changed my PTFE tube with the brand Capri corn one. the tube sits flush on the nozzle. I also change my nozzle. my firmware is updated. my filament is PLA and I increased the temperature up to 230 but the problem is staying where it was. I tested my print with and without retraction but got the same result.

Any help would be appriciated

Thank you


ReplyQuote