Forum


 

Screen blinking aft…
 
Notifications
Clear all

Screen blinking after 4.2.7 install

4 Posts
2 Users
0 Likes
1,446 Views
Inked4Evr
(@inked4evr)
New Member
Joined: 2 years ago
Posts: 2
Topic starter  

I just installed my new 4.2.7 and did a firmware update. Everything was going great and started printing with ease. About 30 minutes into the print the screen blinked like a power surge so I resumed the print. It started up fine and printed for about 5 minutes and then starting to blink and surge over and over. Finally pulled the plug waited 10 minutes and now it won’t load up but keeps surging.


   
ReplyQuote
kevin
(@kevin)
Noble Member
Joined: 2 years ago
Posts: 1045
 

@inked4evr Hello, Can not sure what is wrong with your printer. I think you will find something if you follow this video and check your printer.

https://www.youtube.com/watch?v=85nErXUIoBE


   
ReplyQuote
Inked4Evr
(@inked4evr)
New Member
Joined: 2 years ago
Posts: 2
Topic starter  

@kevin found out a wire was lose, the cheap screwdriver made it hard to tighten it. Working great. Not to adjusting this BL Touch 


   
ReplyQuote
kevin
(@kevin)
Noble Member
Joined: 2 years ago
Posts: 1045
 

@inked4evr Glad to know you found the issue. Sometimes problems are caused by small details. Have a nice day.


   
ReplyQuote