Notifications
Clear all

S axis arm slanted


Quarinteen
(@quarinteen)
New Member Registered
Joined: 4 weeks ago
Posts: 1
Topic starter  

Hello I have an ender 3 and I cannot get the z arm level. It is dipping by .08 mm on the right side with out the stepper. 

This is why I am having such a problem leveling my bed. You may want to get a caliper and see if yours is too if you can’t level it. 

I have loosened and tightened the 3 screws but it’s doing nothing. Outside of that I do t know what else I can do. Any suggestions? 


ReplyQuote
kevin
(@kevin)
Prominent Member Admin
Joined: 5 months ago
Posts: 900
 

@quarinteen Hi, friend. Have you followed these steps to do an adjustment?


ReplyQuote