Forum

 

Forums
General Discussion
Ender-3 Series
Problem with Displa...
 
Notifications
Clear all

Problem with Display upgrade to V2

    Last Post
  RSS

zworka
 zworka
(@zworka)
New Member Registered
Joined: 3 months ago
Posts: 1
Topic starter 03/05/2022 2:15 am  

Hi,

I have an Ender 3. I bought a new 4.2.7 silent board and everything works fine. I have the firmware from the crality Ender-3Marlin2.0.6HW4.2.7GD website. I bought a display from V2 and after plugging in, the screen is black and beeps all the time. I tried to upload the soft found on this forum to the screen, but it did not work. From this thread: https://forums.creality3dofficial.com/community/firmware-software-help/screen-firmware-for-ender-3-v2-4-2-7-board/ How can I run this screen?

 


ReplyQuote
  All forum topics
  Previous Topic
Next Topic