Notifications
Clear all
Topic starter
27/03/2022 6:03 am
I have a fairly new (have had it less than 1 week) Ender 3, using Cura 4.13.1. I’ve successfully ran a few prints through it, but now the prints won’t start. The information screen makes it appear that the extruder is still heating, but everything appears to be up to temp. Anyone else experienced this?
Topic starter
28/03/2022 12:23 am
I’m noticing the estimated print time is increasing very slowly. I don’t understand if this is a printer or gcode file issue. I’ve tried different files that previously printed and am getting the same result.
29/03/2022 8:30 pm
Hi, check your sd card if it works properly
