Forum


 

Noob with a CR Touc…
 
Notifications
Clear all

Noob with a CR Touch problem.

2 Posts
1 Users
0 Likes
111 Views
Eace
 Eace
(@eace)
New Member
Joined: 3 months ago
Posts: 2
Topic starter  

I have an Ender 3 V1, and to date I’ve installed the Sprite Extruder Pro, Dual Z drive, a 4.2.7 main board and it was working fairly well.  I decided to add a CR Touch, and it will not level the bed.  I’ve set the z offset per the instructions, but when I tell it to level the bed it positions the CR Touch off the bed and stops.

 

The last time I tried to flash the newest firmware, it was in Chinese on the display.  Any help?


   
ReplyQuote
Eace
 Eace
(@eace)
New Member
Joined: 3 months ago
Posts: 2
Topic starter  

I managed to roll my own firmware, and all is working now.


   
ReplyQuote