Notifications
Clear all
Topic starter
26/06/2021 2:13 am
It seems like the gcode for some of my laser engravings has an issue with turning the laser on and off properly. I would like to run it through a simulator that shows the path and the laser status (on/off) in different colors so that I could manually correct the code at the appropriate location. Otherwise, I'm not sure how to even identify where the issues are. I am attaching an image to show what I mean, but you can tell that the laser is on during a travel phase as it is much lighter than the burning phase. i circled a few examples in red but there are plenty to go around.
Does this already exist or is there a better way to resolve this? Using the Creality Workshop software on an Ender 3Pro with a Sovol laser attachment.