Forum

 

Is this Elephants F...
 
Notifications
Clear all

Is this Elephants Foot?


Rebel JD
(@rebel-jd)
New Member Registered
Joined: 7 months ago
Posts: 3
Topic starter  

I have an Ender 3 Pro and I can't seem to get rid of the elephants foot on my prints.  I leveled the bed several times, set the Z height, adjust bed temperature, and played around with a lot of settings in Cura  (4.11).   Nothing I've done has had a significant impact.  The problem doesn't appear to be at the lowest layer, rather its up several layers.  I've attached a picture (not sure if I did that right).  Another thing that may be related is that I have to adjust the Z scaling by 110% to get accurate Z dimensions.  X&Y dimensions are ok.  Any help would be appreciated.


ReplyQuote
Topic Tags