Infill area not smo...
 
Notifications
Clear all

Infill area not smooth. HELP!


mechman29
(@mechman29)
Screw Registered
Joined: 2 months ago
Posts: 1
Topic starter  

Hi everyone! 

When I print something that has an infill, the nozzle cuts across the previous infill and snaps it. I have watched many videos where peoples infill are perfect, yet mine are all snapping as the nozzle crosses it. What in the heck am I doing wrong? I use Cura, I have a Ender 3 v2. Using PTEG. Bed at 70 and nozzle at 250 (recommended on roll of PTEG).

Can someone help me figure this out? I'm sure it's a cura issue within my settings. Or, maybe not! HELP! I've included a pic to show you what I am talking about. 


ReplyQuote
Topic Tags
Eli liu
(@eli-liu)
Power Supply Customer
Joined: 8 months ago
Posts: 462
 

You can print a test gcode in the sd card when you got the new print. If the test model is good, you should check the slicing settings, otherwise, printer issues.


ReplyQuote
CYT
 CYT
(@cyt)
Cooling Fan Admin
Joined: 2 months ago
Posts: 42
 

Sometimes when the nozzle is too close to the printing bed, it may also cause a problem as well. I would try to adjust the nozzle height when doing the leveling process. Please let me know if this helps.


ReplyQuote
Scroll Up