Forum

 

Gcode files not sho...
 
Notifications
Clear all

Gcode files not showing after installing touchscreen


vampirecadet
(@vampirecadet)
New Member Registered
Joined: 4 months ago
Posts: 1
Topic starter  

Hi there, excuse me if this is a silly question, but I'm a newbie.

I installed a touchscreen on my Ender 3 Pro today, have installed the screen and board firmware from the SD and both seemed to go well but none of my files show on the display when I insert an SD card full of Gcodes now -  which worked perfectly before I installed the screen.

The rest of the machine is working - bed heats, nozzle heats, etc  but just can't get the files to show so I can't print anything. Any ideas for me? Is there something from the DWIN_SET I also need to install to make them show up? I did try a few of the .bin files in there but none loaded up for me. 


ReplyQuote
tomlin93
(@tomlin93)
New Member Registered
Joined: 4 months ago
Posts: 2
 

Did you get this sorted Vamp? I have run into the same issues 


ReplyQuote