Firmware for Ender ...
 
Notifications
Clear all

Firmware for Ender 3 pro with 400xl extender kit with 4.2.7 mainboard and BL touch 3.1, filaments runout sensor ,v2 screen mirco swiss hotend setup .


Jay
 Jay
(@jay)
Nozzle Registered
Joined: 2 months ago
Posts: 3
Topic starter  

Firmware for Ender 3 pro with 400xl extender kit with 4.2.7 mainboard and BL touch 3.1, filaments runout sensor ,v2 screen mirco swiss hotend setup . I need help setting up the firmware 


ReplyQuote
3nderUser
(@3nderuser)
Extruder Registered
Joined: 3 months ago
Posts: 110
 

What exactly is question?

Compiled this one for you.

4.2.7 mainboard

Changed bed to 400 x 400 .. Max Z height to 500
Display to DWIN display
BLtouch enabled.. Use pin G and OUT for black/white BLtouch
Enabled filament runout sensor
Nozzle_Park_Features and Advanced_Pause_Feature enabled.

 

When trying: Set your nozzle higher above the bed and when homing push probe in with your finger to see it works before digging into the bed. If not response turn off power switch before hitting the bed.

Maybe this one better, Smith3d:


ReplyQuote
Jay
 Jay
(@jay)
Nozzle Registered
Joined: 2 months ago
Posts: 3
Topic starter  

@3nderuser

Does this also work with dual z motor 


ReplyQuote
3nderUser
(@3nderuser)
Extruder Registered
Joined: 3 months ago
Posts: 110
 
Posted by: @jay

@3nderuser

Does this also work with dual z motor 

To be honest, I don't even know if it works with single Z motor. 4.2.7 board has only connector for one Z motor. If both motors are on same connector I think there would be no problem.
I'm just regular guy, no pro. Compiling (to me) is trail and error so just try out and see if everything works fine. If not, can always change settings and compile again.
I did not have 4.2.7 board to test the compiled firmware.


ReplyQuote
Jay
 Jay
(@jay)
Nozzle Registered
Joined: 2 months ago
Posts: 3
Topic starter  

Ok sounds good thanks 


ReplyQuote
Scroll Up