Forum

 

Filament bunching a...
 
Notifications
Clear all

Filament bunching after perfect line.


houghchrst
(@houghchrst)
New Member Registered
Joined: 3 months ago
Posts: 2
Topic starter  

I have downloaded some G Code programs for leveling my Ender 3. They seem to work, I got the outside square to print just fine but when it pauses print to go to the next inside square it begins bunching. I cannot tell if it is dragging on the bed or if it is air printing. I have been messing with this on and off for three days and this is the best I have gotten. A single perfect line around the perimeter. Any ideas?


ReplyQuote