Forum


 

Ender 3 S1 Pro not …
 
Notifications
Clear all

Ender 3 S1 Pro not flashing firmware

3 Posts
2 Users
0 Likes
1,516 Views
SuperShift
(@supershift)
New Member
Joined: 7 months ago
Posts: 1
Topic starter  

I registered especially for this post because I bought an Ender 3 S1 Pro and wanted to flash Klipper. But it does not work. Not even the original firmware can be reflashed, which means that Creality’s official firmware updates can also not be installed. Nothing happens!

And it seems that I am not the only one with this problem. On reddit and other forums there are people who also report about it.

My Ender 3 S1 Pro has the new version with the STM32F401 controller board. The older F103 can be flashed. Btw, there are also S1 (without Pro) but with F401 which also can’t be flashed.

Does anyone have a solution for this? Or is the printer practically dead?

Here you can find a video: https://www.reddit.com/r/ender3/duplicates/u0dkm5/ender_3_s1_pro_not_flashing_firmware/

 


   
ReplyQuote
3dhotdog
(@3dhotdog)
New Member
Joined: 2 months ago
Posts: 2
 

Did you ever get this solved? I just ran into this with my one week old Ender 3 S1 Pro. It’s now non-functional. I’ve tried a bunch of posts suggestions. However, no matter what I do it neither loads a new firmware or boots to a functional state. I emailed Creality for help but haven’t heard back. 


   
ReplyQuote
3dhotdog
(@3dhotdog)
New Member
Joined: 2 months ago
Posts: 2
 

Got this fixed. Followed the instructions of the top comment (from “BenFriedland” on this youtube page: https://www.youtube.com/watch?v=NmoRRFW4zTc

I needed to find the April and June firmware, I downloaded them from here:

https://drive.google.com/drive/folders/1cEFQc37BIsDikt9nvE-NQVH3flJmUQae

 

Good luck future people!


   
ReplyQuote